There are currently no product reviews.
Hello from Germany - thank you very much for the manual for my Sharp "Searcher" - the handling of your internet area is outstanding..Mike
I am very happy with the owner's manual. I bought a used Casio and was so relieved that I was able to get a hold of a owner's manual. It was very easy to download the manual and I had no problems with printing it. Thank you! Nancy Whalen
The purchased manual is an high-quality scan of the original JVC paper-based OwnerΒ΄s Manual. I am very satisfied!
Very satisfied with received document, all is right, Thank You very much, it was a Pleasure to work with You.
great site, the most easy and fastest way to find the manual you need, no 5 star because the manual was only available in german, but I speak german as well so no problem for me.
1 Insert the rechargeable batteries with the 0 and 9 marks correctly aligned. 2 Connect the AC adaptor. 1 to DC 5~6 V jack 2 to a wall outlet 3 Keep sSTOP/OFF/CHARGE pressed for about 2 seconds to start charging. âC-onâ appears and the battery indicator blinks. When charging is completed, âC-OFFâ flashes a few times, and battery indicator goes out. After charging, disconnect the AC adaptor.
Recharge the batteries when lights. If the unit remains in use after âLo-bAttâ is displayed and the current operation will stop.
Time to recharge the batteries
When the recharging stops after only few minutes or the batteries cannot be fully recharged, press sSTOP/OFF/CHARGE while pressing PLAY MODE to start force charging. â¢ Do not activate the force charging on the unit when there is no battery inserted or when dry cell batteries were inserted. Doing so may cause malfunction.
To stop charging
Press sSTOP/OFF/CHARGE during charging.
The product you have purchased can be powered by nickel cadmium batteries which are recyclable. At the end of their useful life, under various state and local laws, it is illegal to dispose of these batteries into your municipal waste stream. Please call 1-800-289-2492 for information on how to recycle these batteries.
USING ON AC HOUSE CURRENT
Connect the supplied AC adaptor in the same way as when recharging the batteries. During operation on AC house current, all of the battery indicators turn off.
HOLD switch â D
When operating with the main unit, release HOLD on the main unit. â a When operating with the remote control, release HOLD on the remote control. âb When not using the unit, set both HOLD to the hold position. â c Accidentally pressed buttons will not function. If buttons are pressed when the HOLD switch is set to the HOLD position, âHOLdâ flashes in the display.
Turning on and off â D
Turning the power on
Press e PLAY/PAUSE. Power is turned on and playback starts.
âErrâ appears on the display in the following cases: âWhen you try to play the unit without a disc in the disc compartment. âWhen you play a disc placed upside-down or a defective disc.
Turning the power off
If no new operations are done within 30 seconds from the end of last operation, the power is turned off automatically. (Auto power off function) â¢ You can turn off the power by pressing sSTOP/OFF/CHARGE before it is automatically turned off.
Standby mode â D
When an operation finishes, the unit goes into standby mode until the auto power off function automatically turns off the power. To enter standby mode, press e PLAY/PAUSE to start playback, then press sSTOP/OFF/CHARGE.
Adjusting the sound
Volume â E
After setting the VOL control of the main unit to the almost center, then adjust the VOL control of the remote control.
DSL â E
Press DSL for more powerful sound and deeper bass. : Deep bass is emphasized. : Normal sound
Inserting a disc â F
1 Slide the OPEN switch to open the disc compartment. 2 Place a disc in the center with the label side facing up. 3 Close the disc compartment.
Pick up the disc, holding its edge, while pressing the pivot gently.
To remove the disc â G Note
â¢ The unit may not play a CD-R/RW disc that is recorded on personal computers or some kinds of CD-R/RW recorders because of differences in recording platforms. â¢ Do not attach any seal or label to either side (the recordable side or the labeled side) of a CD-R/RW disc. It may cause malfunction.