This service manual is a good copy of the original, complete and fully readable. It is really useful to repair my Tv set following its clear instructions.
I was having a hard time finding the problem with this Mackie 1604 unit. I didn't have a schematic. Went looking on the web and found your site and the price was more then reasonable. Ordered it and within the hour had the manual and within 15 minutes had the unit fixed. Best $4.99 I ever spent. Thank you.
Doug
Text excerpt from page 11 (click to view)
3. Confirmation of Sled movement
By pressing the F.SKIP or B.SKIP button continuously during the TEST MODE, it is possible to transfer the pick-up to either the outer side or inner side.
4. Confirmation of the RF level
Test point: RF and VC (Vref) Test disc: TCD-782 Confirm that the RF waveform is as shown below.
0.8Vp-p or more
VOLT/DIV: 200mV TIME/DIV: 0.5us
5. Confirmation of Tracking balance
Test point: TE and VC (Vref) Test disc: TCD-782 Press the DSL button while playing the test disc and confirm the TE waveform is as shown below.
A VC B
VOLT/DIV: 200mV TIME/DIV: 2ms
A:B=1:1
6. Confirmation of each servo
It is possible to confirm the adjustment value of each servo by repeatedly pressing the MODE button while the disc is playing. The switchover sequence is as stated below. Confirmation mode off � Focus Bias (FB) � Tracking Balance (TB) � Tracking Gain (TG) � Tracking Error Offset (TEO) � Focus Gain (FG) � Focus Error Offset (FEO) � Confirmation mode off Example: Tracking Error Offset (TEO) Adjustment value: 03
te 0
Tracking Error Offset (TEO) display
* Adjustment value is displayed in HEX.