|
|
|
Who's Online
There currently are 5731 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
MANUAL TUNING
1 Press the TUNEF?IBAND button to select the band repeatedly. U and LH models: ~M~AM K model:
rFM~Mw
If the power was off, the previously (Direct Play Function). When using the remote control Press the BAND button.
�--+LW1 tuned station will be played
2 Press the K a station.
BAND
DOWN or UP W
button to select
Each time the button is pressed, the frequency changes. When a station is received, �TUNE is displayed for 2 seconds. During FM stereo reception, �STEREO� is displayed.
1
TU\ER
To search for a station quickly (Auto Search)
Keep the W DOWN or UP H button pressed until the tuner starts searching for a station. After tuning in to a station, the search stops. To stop the Auto Search manually, press the W DOWN or UP W button. q The Auto Search may not stop at stations with very weak signals.
When an FM stereo broadcast contains noise
Press the MODE TUNER button while pressing the SHIFT button on the remote control to display �MONO. +u Noise is reduced, although reception is monaural. To restore stereo reception, press the buttons so that �MONO disappears,
To change the AM (MW) tuning interval
The AM (MW) tuning interval can be set to 9 kHz/step step. The default setting are shown below. U and LH models: 10 kHz K model: 9 kHz If you use this unit in an area where the frequency or 10 kHz/
allocation
system is different from the default one, change the tuning interval as follows. Press the POWER button while pressing the +button. To reset the interval, repeat this procedure.
q
When the AM (MW) tuning interval is changed, all preset stations (see page 20) are cleared. The preset stations have to be set again.
18
|
|
|
> |
|
