Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Text excerpt from page 21 (click to view)
Operation with tape One-Touch Recording (OTR)
Your VCR allows you to make recordings using a variety of simple methods: One-Touch Recording (OTR) start recording immediately for a set period of time or until the video cassette runs out. Your VCR incorporates Long Play (LP) which enables you to record up to twice the amount of time on a video cassette. For example an E-180 will record up to 180 minutes using Standard Play (SP); using LP you will be able to record up to 360 minutes. Please note there will be a slight loss in picture and sound quality when using LP.
5 6 7
Press SPEED if you wish to record in Long Play or Standard Play. SP will produce improved picture and sound quality, however LP will provide twice as much recording time as SP. Press REC/OTR to start recording. RECORD will appear on the TV screen. Press REC/OTR several times. Each successive press will increase the record time by 30 minutes until you reach a maximum of 9 hours. Press PAUSE/STEP to avoid recording unwanted scenes. Press PAUSE/STEP to continue recording. Tapes can be paused for up to 5 minutes; RECP will be displayed when a tape is paused. After 5 minutes your VCR will stop recording to prevent damaging the tape or your VCR.
1 2 3 4
Make sure that you have correctly connected your VCR as described earlier in this book. Press POWER to turn on your VCR. Insert a video cassette with protection tab into your VCR. The video cassette should have the window side facing up and the arrow facing away from you. Press 3 or 4 to select the programme number you wish to record. You may also directly select programme number using the numbered buttons on the remote control. If you wish to record directly from the SCART or RCA sockets repeatedly press AV until the socket you wish to record from is displayed. AV 1 for recording from EURO AV1 SCART socket on the rear of your unit. AV 2 for recording from EURO AV2 SCART socket on the rear of your unit. AV 3 for recording from AV 3 IN VIDEO and AUDIO (Left & Right) sockets on the front of your unit.
8
Press STOP to end recording. Press EJECT. EJECT will appear on the TV screen for a few seconds.
Notes If you do not wish to record on a tape (this can happen quite easily by accident!) remove the protection tab on the back edge of the video cassette. It is possible to record on a video cassette with the record protection tab removed by covering the hole with self adhesive tape. Remember you can record one programme while watching another by starting your one-touch recording, press TV/VCR to select TV mode and then selecting a different channel on your TV.
