|
Who's Online
There currently are 5616 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
About one hour after checkout, the manual was available for download. Clear reading and detailed. Thanks
;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
;
We received the manual in a timely manner and it was exactly what we were expecting.
;
Excellant, finally this is want I need and searching for The service manual is fantastic and thank you to owner-manuals.com and its service. Price is reasonable. It's a bit slow on my end in downloading but manage to receive the whole manual without a break. once again, thanks.
ADJUSTMENT
A MAIN C.B
PRACTICAL SERVICE FIGURE
<TUNER SECTION>
<FM SECTION> Sensitivity : (IHF, THD 3%)
VR1
<TAPE SECTION>
3000Hz ± 60Hz Less than 0.50% (RMS) 35 ~ 50 g-cm (FWD, REV) More than 36 g-cm 60 ~ 170 g-cm 3 ± 1.5 g-cm (FWD, REV) More than 43dB (PB, DC) Less than 3% (PB, DC) Except YZ1: Less than 7.0mV (PB, DC, VOL MAX) YZ1: Less than 4.0mV (PB, DC, VOL MAX) 63Hz + 2/-4dB ~ 8kHz + 3/-4dB TTA� 100 TTA� 210 TTA� 320 (120µ) TTA� 330
VOLUME
L104
IC1
PVC1 L102 TC101 TC104 TC102 L103 TC103
2 3 2
Tape speed : Wow & flutter : Take-up torque : Signal to noise ratio : F.F torque : Rew torque : Distortion : Less than 3%[at 98MHz] Back tension : Intermediate frequency : 10.7MHz ± 0.1MHz S/N ratio : FM stereo separation : More than 16dB[at 98.0MHz] Distortion : Noise level : <AM SECTION> Sensitivity : (S/N 10dB) Less than 58dB [at 600/1000kHz] Frequency response : Less than 56dB[at 1400kHz] Test tape : Signal to noise ratio : More than 28dB[at 600kHz] Less than 17dB[at 88/98MHz] Less than 18dB[at 108MHz] More than 50dB [at 88/98/108MHz] More than 29dB [at 1000/1400kHz] Distortion : Less than 5%[at 1000kHz] Intermediate frequency : 455kHz ± 3kHz
SFR 1
L105 PHONES J1
IC BLOCK DIADRAM
6
1
5 3
4
67
IC, LAG668FT2
L101 BAR ANT
<TUNER SECTION>
1. AM IF Adjustment L105 ....................................................................... 455kHz 2. AM Frequency range Adjustment L104 ..................................................... 515 ± 5kHz<YZ1> L104 ........................................ 517 ± 5kHz<YU,YL,YL1> TC104 .............................................. 1670 ± 10kHz<YZ1> TC104 ................................. 1775 ± 10kHz<YU,YL,YL1> 3 AM Tracking Adjustment L101 ....................................................................... 600kHz TC101 .................................................................. 1400kHz
<TAPE PLAYER SECTION>
6. Tape Speed Adjustment Settings : � Test tape : TTA�100 (TAPE CENTRE) � Test point : PHONES JACK (J1) � Volume : NON-CLIP (MAX-10dB) � Tape/Radio : TAPE � Tape select : NORM � Adjustment location : SFR1 Method : Play back the test tape and adjust for 3000Hz ± 15Hz.
4. FM Frequency range Adjustment L103 ................................. 87.0 ± 0.1MHz <YU,YL,YL1> L103 ............................................. 87.4 ± 0.1 MHz <YZ1> TC103 ............................ 109.0 ± 0.1MHz <YU,YL,YL1> TC103 ......................................... 108.3 ± 0.1MHz <YZ1> 5. FM Tracking Adjustment L102 .................................................................... 88.0MHz TC102 ............................................................... 108.0MHz
7. Head Azimuth Adjustment settings : � Test tape : TTA�330 � Test point : PHONES JACK (J1) � Volume : MAX � Tape/Radio : TAPE � Tape select : NORM � Adjustment location : Head azimuth adjustment screw Method : Play back the 8kHz signal of the test tape and adjust so that the output becomes maximum.
9
10
|
|
|
> |
|