|
Who's Online
There currently are 5813 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
;
The downloaded quality was as good as the orignial
;
This is a great and complete Service Manual for the Sharp GF8585HB. Giving full and detailed technical insight. Good to find these manuals online.
Pin No.
36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64
Pin Name
LVDD LCHO LVSS RVSS RCHO RVDD MUTER XVDD XOUT XIN XVSS SBSY EFLG PW SFSY SBCK FSX WRQ RWC SQOUT COIN CQCK RES T11 16M 4.2M T5 CS T1
I/O
� O � � O � O � O
Description
Left channel 1-bit D/A converter power supply. Left channel 1-bit D/A converter output. Left channel 1-bit D/A converter ground. Normally, 0V. Right channel 1-bit D/A converter ground. Normally, 0V. Right channel 1-bit D/A converter output. Right channel 1-bit D/A converter power supply. Right channel 1-bit D/A converter muting output. (Not used) Power supply of crystal oscillator. For the connection of a 16.93MHz crystal oscillator.
I � O O O O I O O I O I I input. I O O O I I I LC78622NE reset input. Test output. Set to open (normally, "L" output.) (Not used) 16.9344MHz output. (Not used) 4.2336MHz output. Test input. A pull-down resistor is incorporated. (Connected to 0V) Chip select input. (Connected to 0V) Test input with no pull-down resistor. (Connected to 0V) Ground of crystal oscillator. Normally, 0V. Subcode block sync signal output. (Not used) C1, C2, single, duplex correction monitor. (Not used) Output of subcodes P, Q, R, S, T, U and W. (Not used) Subcode frame sync signal output. Falls when the subcode is set to the standby state. (Not used) Subcode read-out clock input. Schmitt trigger input. ("L" is applied when not used.) (Connected to 0V) 7.35kHz sync signal output obtained by dividing the oscillator frequency. (Not used) Subcode Q standby output. Read/write control input. Schmitt trigger input. Subcode Q output. Command input from the microprocessor. Command input retrieval clock or subcode retrieval clock input from SQOUT. Schmitt trigger
� 22 �
$4.99 CSDTD28 AIWA Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|